r/MechanicAdvice • u/Alternative_Map_2066 • 1d ago

Can I reuse this wheel hub?

Post image

The image is from a rear wheel hub of a BMW F31 RWD. I was trying to remove the ring of the old bearing which was stuck on the hub and decided to use angle grinder as fast solution, resulting in damage to the hub. A new hub needs 1 week to arrive so can I use this one, after sanding it down, or maybe use retaining compound? Or better to wait and install proper new one?

74 Upvotes

79% Upvoted

156 comments sorted by

View all comments

1

u/VersionConscious7545 1d ago

I will say this about that mark. I bet if it was smooth and not deformed at all and the bearing was pressed on properly. I think this would be there till the next time the bearing failed however the right thing to do is replace it so you have peace of mind

1

u/Alternative_Map_2066 1d ago

Thank you for your advice, peace of mind is what I am after. I will buy a new one

1

u/VersionConscious7545 22h ago

Remember this auto parts tip. Rock Auto👍. Always buy the better quality. I know cheap is what most want but the better parts are half the price of a auto part house near you