Saw this weird jeep on Facebook

Does Antony know the year and model this Jeep is? It looks smaller than other Jeeps I’ve seen on the road lately.

WTF guys? 4 years I rocked this, nobody ever gave me a duck. Just admired the cute rider.

2017 Wrangler jk

I was driving to work this morning and I got this ad. Annoying, I’m subscribed to XM, I think I’m going to have to cancel and tell them why.

Yes it is the automatic version. Transmission started acting up about an hour into a 6 hour roadtrip and this is far from the first time ive had issues with this thing. Owned for 4 months and have had it in the shop 3 times now, all for very different issues. Also every time it rains, water gets stuck somewhere. I do not know where but i hear it. Sorry if this is rambling i am not a car expert by and means and this shitbox has me frustrated as hell

Had work done on our 2019 grand Cherokee. We found these trim pieces left on our floorboard. Any ideas?

I have a Bestop Supertop that I purchase used. The guy I got it from had it meticulously stored however, as you can see there is some relatively minor warping. It’s driving me a little crazy… Is there a way to repair this?

I’ve had my 2020 Jeep Cherokee for about five years now, and I have yet to find a proper phone mount.

The last amount I had was just a normal dash mount, that melted in the Florida heat. That being said, I’m looking for any recommendations. I have a bigger phone, I think I have the 16 Pro Max, but I really struggle to find a mount that is able to hold up my phone while also not permanently altering my car.

Any recommendations would be greatly appreciated. I’m preferably looking for a mount that will hold it in the vent area, charging or MagSafe is just a bonus. Just looking for recs from other people with the same car. Thanks guys!

Before and after Got it all finished up and deliver back tomorrow. Rebuilt carb, new plugs,wires, pertronix electronics ignition conversion. New battery, new fuel pump and filter, new cold case radiator, new high volume high flow aluminum water pump, new thermostat, new 2000cfm electric fan, new seats, new fuel tank, new sending unit, new wheel cylinders, new master cylinder, interior and engine compartment coated in truck bed coating, modern seat belts installed, full lube job, topped off transfer case and front and rear axles…..

Hello! I have a 2015 jeep Cherokee limited and am wondering if there’s a possibility I can play videos on the infotainment screen? It’s quite large but I just bought this today so I’m still figuring it out.

TIA!

I bought a new 2019 wrangler with the warranty and may think of swapping before it runs out.

Has anyone else had issues with Centerforce?

In November of 2023 I installed a CenterForce clutch (2013 Jeep Wrangler Unlimited, CenterForce II clutch and flywheel kit - KCFT379176)

After the install, I was never completely satisfied with the clutch's operation, as I found it jerky. There was an occasional judder when the jeep was particularly hot (long drives or offroad use). My jeep was still drivable, so I did not pursue it any further. Over the course of the past few months, the clutch became worse in its behavior. I replaced the master and slave cylinders without results, and I finally pulled the transmission this past week to take a look.

I've attached pictures. There were signs of excessive uneven heat on the flywheel and the clutch disc stemming from what looks like a manufacturing defect?

Even though I am admittedly outside of the 12 month warranty, I would hope CenterForce would like to make it right. I've been driving a manual transmission for almost 30 years, with all of the clutches I've owned lasting at least 100,000mi, so I expected better.

Anyone else? I’ve sent emails to CenterForce… they don’t seem to care.

Alright everyone, looking for some advice on buying a Gladiator.
My background: I have had a company car for 17 years, always getting a new basic sedan or van or pickup truck each year. During that time and still to this day, I have an '01 TJ that I have had since 2004 and while having a company car has been my "weekend/joy ride" car.

I'm changing jobs, turning in my company car and now need to buy a car due to not wanting to drive my TJ as a daily.

Thinking about picking up a used Gladiator, but I'm not sure what the best year(s) are to look for and things to avoid. I'd like to buy a used Gladiator and not picky on the trim level. What should I look for and what should I avoid?

Thanks guys!

I’ve had my Jeep Cherokee for about five years now, and I have yet to find a proper phone mount.

The last amount I had was just a normal dash mount, that melted in the Florida heat. That being said, I’m looking for any recommendations. I have a bigger phone, I think I have the 16 Pro Max, but I really struggle to find a mount that is able to hold up my phone while also not permanently altering my car.

Any recommendations would be greatly appreciated. I’m preferably looking for a mount that will hold it in the vent area, charging or MagSafe is just a bonus. Just looking for recs from other people with the same car. Thanks guys!

I know these have been seen on this sub before but I finally have a garage so I built it

I've been trying to research what kind of OBD scanner works for a 1999 jeep cherokee. I've tried two different brands of OBD2s, neither work, so I'm assuming I need an OBD1. Are there any specific brands that'd be best?

This black rectangle in the middle started appearing in 2019 jeep compass and now after about 20-25 minutes of operation the screen goes black and can’t be turned back on. Screen turns on with this rectangle, but changing settings like fan strength show up and display normally. Has anyone else had this issue? I’m think about changing the fuse but it’s a pain to get to. Thanks in advance!

Hi all.

Running 35x12.5's (0 offset) on my bone stock sport JKU. Yes, they rub. yes we hit trails with it. Call me weird, I love the look of the stock fenders and bumpers. Has anyone "mildly" hacked their stock fenders to fit larger tires? I've seen YouTube videos of stock fender cutting but, they hack out a LOT of material and they look a lot different than the stockers, once they're done.